UCDS Forum

Hello
C-MAX 2011, after update flash in oryginal BV61-2C405-AF ABS, ABS is death. No communication
The car does not start.
I changed the module ABS, communication is ok, but car still not start.
Please help

I try forced updade , dont work.
Settings like in the picture. Everything set up is ok ?

there was a error of checksum in ABS module, that's why I made the update ...

Maybe I'm doing something wrong?

I remove fuse 19 (after ignition to ABS), click YES and put fuse back, and.... nothing is happening
Bootloader is damaged ?

ps. I try update second module, from another car and now i have two dead module
I bought a third one, but I do not know how to add it to the car

Not need MM-CAN (its for switch to Multimedia Bus)

Try remove power from battery and connect before on 15 sec after message

I tried to disconnect the battery before, without the effect
Now I put switch instead of a fuse 19

I tried to encode Forscan, without result.
No comunication with PATS, in BCM I did not find a function PATS or encode module.
You can help me how to do it with Forscan (of course with extension license)

Why you help forscan? Im confused , forscant cant help you!
You abs now have not correct software and freeze (prelift focus have not correct ABS modules for update)
Modules on Focus 3/CMax with *-AF or before , after update sw cant start. In update wizard show Warning before about it.
One way try reflash in "dead mode",
Remove power from ABS, Enable Ignition, after press button before 15 sec, give power on ABS. Try some runs.

Artist, I tried when the second module was still alive, it's obvious